Alinco DX-801 Instruction Manual download pdf (Page 28)

MFJ-925 Super-Compact IntelliTuner Automatic Antenna Tuner Instruction Manual

Icom Radio Interface

The MFJ-5114I radio interface allows users of AH-3 or AH-4 compatible Icom transceivers to connect to

the MFJ-925 IntelliTuner™ Automatic Antenna Tuner. With this interface, control signals are connected

between the radio and the tuner. The operator can then control the tuner with a single push of the

[TUNER] button on the front panel of the radio. Supported Icom radios are IC-706, IC-707, IC-718, IC-

725, IC-728, IC-736, IC-738, IC-746, IC-756, IC-7000, and any Icom radio that supports the Icom AH-3

or AH-4 tuner.

Connections

1. Turn the tuner off. Set jumper JP2 to the “I” position.

2. For IC-7000, make sure jumper JP4 inside the MFJ-925 is removed.

3. Insert the 8-pin modular plug into the tuner’s RADIO INTERFACE jack.

4. Important

: Make sure the DC power to the radio has been turned off. The radio does not fuse the

DC power to the tuner, and damage to the radio can occur if the interface’s power connection

comes in contact with ground.

5. Connect the 4-pin molex connector to the mating 4-pin molex connector, marked as TUNER, on

the back of the Icom radio.

6. Push the [POWER] button on the tuner to the in position and then power on the radio.

7. Some Icom radios, such as the IC-706, automatically check to see if an external antenna tuner is

connected during power on. For other Icom radios, such as the IC-718, the Tuner Type menu in

the radio menu system must be enabled. Refer to your radio’s operating manual for accessing the

menu system and preparing the AH-4 antenna tuner operation. Use IC-718 as an example:

a. Push [PWR] for 1 second to turn power off.

b. While pushing and holding [SET], push [PWR] to turn power on.

c. Push [UP] or [DN] one or more times to select TUNER.

d. Rotate the Main Dial to select “4” for AH-4 antenna tuner.

e. Push [PWR] for 1 second to turn power off.

f. Push [PWR] to turn power on again.

Operation

The operation of the MFJ-5114I radio interface is similar to the operation of the AH-3 or AH-4 described

in the Icom radio’s operating manual.

1. Push and hold the [TUNER] button on the radio for one or two seconds to initiate automatic

tuning process. The radio will automatically switch to CW mode, transmit a 10-watt carrier, and

start the tuning process. When the tuning process is completed, the radio will stop transmitting,

return to its previous mode and power setting.

2. Push the [TUNER] button on the radio quickly to bypass the tuner or to cancel tuning in progress.

Note the [TUNE] button on the tuner

will also key the Icom radio interface.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

No comments

Alinco DX-801 Instruction Manual Page 28