Alinco DR-635E Instruction Manual download pdf (Page 9)

Initial Installation

For a mobile station set up

Location

The transceiver may be installed in any position in your car, where the controls and microphone are

easily accessible and it does not interfere with the safe operation of the vehicle or the performance

of the set. If your vehicle is equipped with air bags, be certain your radio will not interfere with

their deployment. If you are uncertain about where to mount the unit, contact your vehicle's manu-

facturer. Please refer the next page for positioning the front control unit.

Installing a Mobile Antenna

Use a 50 ohm coaxial cable to connect the antenna. Mobile antennas require an appropriate mount-

ing base for proper installation and operation. For more information, see the documentation for

your antenna.

Installing the Transceiver

See the figures below.

IMPORTANT: After installing your antenna, ensure that you have the best possible SWR reading.

High RF environments can cause severe damage to your unit. Ensure that you are not

in a high RF environment when operating the transceiver.

*Use provided screws only(M4 x 8mm)

to fix the bracket. Irregular screws

may damage the circuit-board inside.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 65 66

No comments

Alinco DR-635E Instruction Manual Page 9