26
2
Select a backlight mode as follows:
Using the dial or UP/DOWN key, point the arrow at a desired mode, and then
press the key (the initial setting is the MOMENTARY mode).
AUTO: The backlight is lit for 5 seconds after the dial or key is
used.
MOMENTARY: The backlight remains lit only while the key is being
held down.
ALTERNATE: The backlight is turned alternately ON and OFF every time
the key is pressed.
The display will go back to the CONFIG menu. Point the arrow at END, and then
press the key (or alternatively, press the key, and then press the
key with shown on the display.
Note: If you exit the CONFIG menu by pressing the key, the changed
setting is canceled.
2.11 Turning beep ON/OFF
The beep sound that is emitted when a key is pressed or a specific operation is
performed can be turned ON/OFF and its volume can be controlled as follows:
1
Call up the BEEP screen.
Press the key, and then press
the key while is shown
on the display. The MENU will
appear. Point the arrow at
+CONFIG using the dial or UP/DOWN key, and then
press the key. The CONFIG menu will appear.
Point the arrow at +BEEP, and then press the key.
The BEEP screen will appear.
2
Select a beep sound mode.
Using the dial or the UP/DOWN key, point the arrow at a desired mode, and then
press the key (the initial setting is the HIGH mode).
OFF: The beep sound is turned OFF.
HIGH: The beep sound is emitted at a high level.
LOW: The beep sound is emitted at a low level.
The display will go back to the CONFIG menu. Point the arrow at END, and then
press the key (or alternatively, press the key, and then press the
key while is shown on the display.).
Note: •If you exit the CONFIG menu by pressing the key, the changed
setting is canceled.
• If stereo earphones are used, the beep sound can be heard from the left
earphone only.
Comments to this Manuals